Today we are going to be discussing with you the five most common problems with refrigerators. If you don’t find the issue you’re having on this page, be sure to check the links to other helpful refrigerator repair articles on the right side.  Or, feel free to give us a call any time at [sc:phonenumber]

Number one DIY refrigerator repair is dealing with a stuck fridge fan.

Repair Refrigerator Fan

refrigerator fan repair

When you open your fridge and it is in its run cycle you should hear the sound like of the fan motor spinning. Sometimes what happens is the fan blades get stuck against the side or the fan blade itself goes so far back that it seats against the motor and then the blades get stuck and don’t turn.

The second most common problem with refrigerators is drips from the ceiling.

Now if it’s just small drips it can be caused by food put in that’s hot like boiling or something that had boiled and then set in the fridge without a cover on it. The way to eliminate that is to keep a cover on your food but if you’re seeing excessive drips from the inside center then it may indicate that you have a clogged condensate drain which is a very common problem with refrigerators.

The third most common problem with refrigerators is the compressor not running.

If you listen you can kind of hear the hum of the compressor. So if you don’t hear that sound – that low humming sound that’s different from the fan going – then your starter may need to be replaced on the compressor.

The fourth most common problem with refrigerators is torn gaskets.

The way that you prevent that from happening is to clean the gaskets often and to clean the fridge surface often where it mates because what happens is sticky foods stick in there and then pulling apart from the gasket eventually can tear the gasket and wear out the gasket, so that’s the way to kind of prevent it.

Each door manufacturer, from GE to Samsung, is different so you might have to consult your directions on how to replace your gasket. Some of them will have screws along the inside portion of the gasket in order to change it while others will have a press in place groove that the gasket gets pressed into. Still others, the entire door portion will pull apart so that you can replace the gasket, so each kind is just slightly different.

And the fifth most common problem with refrigerators is being off balance.

What you want is for when you let your fridge door go, you want it to just close nice and gently and close all the way. You want the fridge to aim towards the back just a tiny bit so that condensate goes down and stays along the back of the fridge and settles into the pan that’s on the back, (on the top of the compressor usually). But anyway, you want your fridge to angle towards the back just a tiny bit.

If your fridge is off balance there is usually an adjustment screw, or some fridges have a wheel that is turned that can be adjusted just by lifting up a little bit on the fridge and then turning this either by hand or with channel locks.

[covertplayersinglevideo trvideoid=”d5EzKao5QCU” trdisplaytype=”5″ trnumbervideosdisplay=”1″ trvideoperpage=”1″ trthumbnailwidth=”150″ trthumbnailheight=”100″ trpopupwidth=”500″ trpopupheight=”350″ trvideoalign=”left” trytautohide=”0″ trytautoplay=”1″ trytcontrols=”0″ trytrelvideo=”0″ trytshowlogo=”1″ trytshowtitle=”0″ tryttheme=”dark” trythighquality=”0″]So that’s the five most common problems with refrigerators. For more refrigerator repair and troubleshooting, you might enjoy this video.