Kenmore refrigerator repair Las Vegas

Kenmore refrigerator repair Las Vegas

Is your refrigerator not cooling right anymore? Or do you find the freezer becoming full of ice? If your Kenmore refrigerator is causing you any kind of difficulty at all, you can rely on Best Refrigerator Repair of [sc:city] to get things functioning right for you. And we can do it soon. We are usually readily available for a same-day or following day service call, and there’s no service fee if we do your repair. With experienced, insured and friendly techs, it is no surprise [sc:city] utilizes us for Kenmore refrigerator repairs along with other appliance issues.

Not all refrigerator issues are difficult, and we recognize that quite a lot of you would rather attempt to work things out on your own before bringing in outside companies. That’s why we love to help you here too, by providing a few posts plus videos that may be of use for you. But remember, if you think this can be over your head, you are always better off having a qualified and trained expert tech get things operating once again. After all, you wouldn’t want all the food items within your fridge to end up going bad.

Whether you own a Kenmore refrigerator, or some other major brand, the DIY job we’ll be sharing with you here is something that you can probably handle on your own.  Check it out, and remember, if you need us, call us.

Today we are going to show you how to change the filter cup and housing assembly in your refrigerator. It’s a pretty easy job and all we’re going to need is a 1/4 inch nut driver and a flat blade screw driver. Let me show you how it is done.

Now the first step in this repair will be to turn the ice maker off, just reach in through the bin, lift up on the arm, and tilt the stays in the stop position. Next we will open the refrigerator door, clean any items off the top shelf and remove that shelf just tilt up. Lift the shelf out, set that aside.

Now we got a 1/4 inch nut driver, locate a hold in the housing over to the right hand side. Remove that 1/4 inch hex head screw that will remove the cover. And next we have to remove the two 1/4 inch hex head screws that secure the housing to the back wall of the refrigerator. Slip the housing and filter assembly out.

Now we will take our flat blade screw driver, we will lift up on the retaining clips for the two water lines. We want to take note the two separate water lines so that we get them located in the right place when we replace the part. Reconnect our two water lines, reinstall the two 1/4 inch hex head screws, remove the cover from the old housing, there will probably be a little bit of water come out of this… Set that aside, remove the filter, just pull it out, take note of your filter – if it appeared to be clogged up, its time to replace that as well.

We slide that into the housing, press firmly upwards and it should stay in place. Install our new cover, stir that on clockwise Now I am ready to put the filter housing cover back on, make sure the screw is located in the hole, insert our nut driver and slide it up over the housing. Tighten the screw and hold it in place, and reinstall the shelf. Remember to turn the ice maker back on, and our repair is complete. That’s how easy it is to change the filter cup and the housing assembly.  See, a little Kenmore refrigerator repair wasn’t all that hard now, was it?

Kenmore Refrigerator Repairs

« « GE Refrigerator Repairs
Appliance Repair Done Right – Use The Right Tools » »